The Nighthawk Pro 280 was designed from the ground up to meet the exacting specifications of the Drone Racer. It comes fully tuned with the new Skylight 32 integrated flight control board with four 12Amp BLHeli One shot speed controllers. The power system consists of EMAX 2204 2300 kV motors and 6045 propellers mounted on a 10 degree tilt allowing greater forward speeds without sacrificing elevation. For the FPV racer, the Nighthawk Pro 280 includes a 700TVL camera with optional tilt mounts that allow you a perfect horizontal view in flight, and a 20W-200W video transmitter with a selectable switch, allowing you the option to choose the power output of your transmitter. It is without a doubt an exciting new quadcopter that captures the joy of quadcopter racing!
- Independent designed solid, durable and stable frame, centroid and center of gravity are same even battery installed
- Prebuilt frame and extra accessories, Built with powerful EMAX power system and open source flight controller to ensure power and customizable (RTF model can fly after battery and propellers installed)
- The sturdy copter frame has extensive flight test and endurance test.
- Bright COB rear LED, different LED color can use distinguish copters when group flying (LED power consumption is 4W, which might decrease flying times.)
- All in one design to combine ESC, BEC, and flight controller for easy installation and easy replacement. Plug and play motor, easy for swapping motor and no soldering needed.
- Independent. Independent ESC and flight controller and power supply. ESC switch to perform single ESC calibration and boot pad to perform software and firmware upgrade.
- Flight controller use 32bit ARM micro processor, fast process speed to ensure fast respond
- Gyroscope, magnetometer, and accelerometer and barometer expansion port. With CPPM receiver GPS feature can be enable. (GPS module sold separately)
- Support ANGLE, HORIZON, HEADFREE, MAG, HEADADJ ...etc modes.
- Support RC Input: standard signal, CPPM (PPM SUM) signal, PWM signal.
- Low voltage monitoring and low voltage warning. (Buzzer sold separately)
- Use EMAX 12A ESC, support open source BLHeli and ONESHOT feature; flight controller is based on NAZE32 Skyline32, support open source configuration Baseflight and Cleanflight
- Extra power output and power output switch for LED expansion.